Overview - Omron NJ Series Network Connection Manual

4. Overview

This document describes the procedure for connecting the Displacement Sensor (ZW series)
of OMRON Corporation (hereinafter referred to as OMRON) to NJ-series Machine Automation
Controller (hereinafter referred to as the Controller) via EtherNet/IP and provides the
procedure for checking their connection.
Specifically, it describes the procedure for connecting EtherNet/IP using the EtherNet/IP
settings of the project file that was prepared beforehand (hereinafter referred to as the
"procedure for using the configuration files").
Section 9 A-1 and Section 10 A-2 describe the procedures for setting parameters with
software without using files (hereinafter referred to as the "procedure for setting parameters
from beginning".
To follow the "procedure for using configuration files", obtain the latest "Sysmac Studio project
file" and "Network Configurator v3 network configuration file" (they are referred to as
"configuration files") from OMRON in advance.
Name
Sysmac Studio project file
(extension: smc)
Network Configurator v3 network
configuration (extension: nvf)
File name
OMRON_ZW_EIP_EV100.smc Ver.1.00
OMRON_ZW_EIP_EV100.nvf
4. Overview
Version
Ver.1.00
5