Omron NJ Series Network Connection Manual page 15

Allocation of EIPOutput.CommonControlFlag.F variable
Offset
15 14 13
(word)
+0
+1
EXE: Control command execution bit: Turns ON when the Controller
instructs execution of control commands to the displacement sensor.
SYNC: Measurement synchronous start bit: Turns ON when the Controller
instructs measurement synchronization to the displacement sensor.
ERCLR: Error clear bit: Turns ON when the displacement sensor ERR
Allocation of EIPOutput.CommonControlFlag.W variable
Offset
15 14
(word)
+0 15 14
+1 31 30
Bits 31 to 0: EIPOutput.CommonControlFlag.W uses DWORD data from the
*5: Details on allocation of sensor head 1 control signal
Allocation of EIPOutput.SensorHead1ControlFlag.F variable
Offset
15 14 13 12 11 10
(word)
+2
+3
TIMING1: Timing bit: Turns ON when the Controller instructs start of hold
RESET1: Reset bit: Turns ON when the Controller resets judgment
LIGHTOFF1: Light metering OFF bit: Turns ON when the Controller
ZERO1_T1 to 4: Zero reset execution bit: Turns ON when the Controller
ZEROCLR1_T1 to 4: Zero reset cancel bit: Turns ON when the Controller
12 11 10 9
signal turns OFF.
13
13
29
offset +0 word.
9 8 7
ZEROCL
R_T4
sampling to the displacement sensor.
processing and output of the displacement sensor. If the hold
function is used, the state before the hold function was set will be
restored.
instructs logical beam OFF to the displacement sensor.
instructs execution of zero reset of TASK1 to 4 to the
displacement sensor.
instructs zero reset cancel of TASK1 to 4 to the displacement
sensor.
6. EtherNet/IP Settings
8 7 6 5 4
...
...
...
6 5 4 3
ZEROCL ZEROCL ZEROCL ZERO1_
R_T3 R_T2 R_T1 T4
3 2 1 0
SYNC EXE
ERCLR
2 1 0
2 1 0
18 17 16
2 1 0
LIGHT
RESET1 TIMING1
OFF
ZERO1_ ZERO1_ ZERO1_
T3 T2 T1
12