Work Flow Of "Procedure For Setting Parameters From The Beginning - Omron NJ Series Network Connection Manual

10. Appendix 2 Setting the Tag Data Links Using the Software

10.2. Work Flow of "Procedure for Setting Parameters from the Beginning"

Use the following procedure to make connection settings for tag data links of the EtherNet/IP
using the "procedure for setting parameters from the beginning".
This section describes the detailed procedures for "10.3 Setting the Controller Using
Software" and "10.4 Setting the Network Using Software" (in red frames below) without using
the "configuration files".
The procedures for 7.3 Setting the Displacement Sensor and 7.6 Checking the Connection
Status" are the same as the "procedure for using the configuration files". Refer to the
procedures in Section 7.
7.3. Setting Up the Displacement
Sensor
↓
7.3.1. Parameter Setting
↓
10.3. Setting Up the Controller Using
the Software
↓
10.3.1. Starting the Sysmac Studio and
Setting the Parameters for the
Controller
↓
10.3.2. Setting the Global Variables
↓
10.3.3. Exporting the Global Variables
↓
10.3.4. Connecting Online and
Transferring the Project Data
↓
10.3.5. Settings in Watch Tab Page
↓
Set up the Displacement Sensor.
Set the parameters for the Displacement Sensor.
Set up the Controller using the software.
Start the Sysmac Studio and set the parameters for
the Controller.
Set the global variable to use for the tag data links.
Export the global variables in a CSV file to use as
tags in the Network Configurator.
Connect online with the Sysmac Studio and transfer
the project data to the Controller.
To check data that is sent and received, make
settings in the Watch Tab Page.
54