Omron NJ Series Network Connection Manual page 18

RESETSTAT1: Reset execution state bit: Turns ON when the displacement
LIGHT1: Logical beam lighting state bit: Turns ON when the logical beam is
STABILITY1: Measurement position bit: Turns ON when the measured
ENABLE1: Measurement state bit: Turns ON when the displacement sensor
GATE1: Data output completed bit: Turns ON when the displacement sensor
OR1: Overall judgment result bit: Turns ON when even one of the judgment
ZEROSTAT1_T1 to 4: Zero reset bit: Turns ON when the displacement
HIGH1_T1 to 4: HIGH output bit: Turns ON when the judgment result of the
PASS1_T1 to 4: PASS output bit: Turns ON when the judgment result of the
LOW1_T1 to 4: LOW output bit: Turns ON when the judgment result of the
Allocation of EIPOutput.SensorHead1StatusFlag.W variable
Offset
15 14
(word)
+2 15 14
+3 31 30
Bits 31 to 0: EIPOutput.SensorHead1StatusFlag.W uses DWORD data from
*6: Details on allocation of sensor head 2 control signal (reserved)
Allocation of EIPOutput.SensorHead2StatusReserve.F variable
Offset
15 14 13
(word)
+4
+5
sensor is in the reset execution state.
lit.
value is in the measuring range.
is ready for measurement.
completes control data output when hold is set.
result of the displacement sensor TASK1 to 4 is other than PASS.
sensor TASK1 to 4 is in the zero reset execution state.
displacement sensor TASK1 to 4 is HIGH (HIGH threshold <
measured value).
displacement sensor TASK1 to 4 is PASS (LOW threshold ≤
measured value ≤ HIGH threshold).
displacement sensor TASK1 to 4 is LOW (LOW threshold >
measured value).
13
13
29
offset + 2 words.
12 11 10 9
6. EtherNet/IP Settings
...
...
...
8 7 6 5 4
2 1 0
2 1 0
18 17 16
3 2 1 0
15