Epson AcuLaser C2800 Service Manual page 357

AcuLaser C2800/C2800D/C3800/C3800D
D E
MOTOR ASSY DUP
3)-2
4)
Ground Wire
4)
3)-1
1. Loosen the three clamps to remove the harness of the MOTOR ASSY DUP.
2. Release connector (P/J429) from the mid-connector that is connected to the MOTOR ASSY DUP.
3. Remove the screw (silver, brimmed, 6 mm) that secures the COVER DRIVE DUP to the BRACKET
MOTOR DUP, release the tab, and remove the COVER DRIVE DUP.
4. Remove the two screws (silver, brimmed, 6 mm) that secure the MOTOR ASSY DUP to the
BRACKET MOTOR DUP together with the ground wire, and remove both the MOTOR ASSY DUP
and the PLATE EARTH DUP.
DISASSEMBLY/REASSEMBLY
MOTOR ASSY DUP
1)
2) (J429)
Kmy03231EB
Disassembly/Reassembly
D
ROLL ASSY DUP-2
2)
1)
1)
1)
1. Remove the three screws (silver, self-tapping, 10 mm) that secure the BRACKET MOTOR DUP to
the FEEDER ASSY DUP, and remove the BRACKET MOTOR DUP.
2. Release the tab and remove the GEAR DUP from the shaft of the ROLL ASSY DUP-2.
3. Release the two tabs of the FRANGE PULLEY UP with a mini screwdriver or a similar tool, and
remove the FRANGE PULLEY UP from the PULLEY DUP.
4. Remove the BELT DUP from the PULLEY DUP.
5. Release the tab and remove the PULLEY DUP from the shaft of the ROLL ASSY DUP-2.
6. Remove the BEARING DUPs that secure the left and right ends of the ROLL ASSY DUP-2 by
rotating them in the direction of the arrow.
7. Temporarily slide the ROLL ASSY DUP-2 toward left, pull out the right end of the ROLL ASSY
DUP-2 from the FEEDER ASSY DUP, and remove the ROLL ASSY DUP-2.
Revision C
ROLL ASSY DUP-2
5 )
3)
7)
4)
6)
6)
Kmy03230EA
357
Confidential