Epson AcuLaser C2800 Service Manual page 250

AcuLaser C2800/C2800D/C3800/C3800D
The mid connector should remain connected to the main unit.
C H E C K
P O I N T
3. Disconnect the connector (P/J232) of the harness coming out of the FEEDER ASSY and the
connector (P/J241).
4. Disconnect the connector (P/J234) of the CLUTCH ASSY PH TURN attached to the FEEDER ASSY.
Match the colors of the harnesses of the clutches with that of the harnesses of the main unit.
Harness color of the CLUTCH ASSY PH TURN is blue.
5. Detach the harnesses from the clamps and the tabs of the main unit.
DISASSEMBLY/REASSEMBLY
Blue
4)
Blue
3)
5)
Kmy03027EB
NEXT>>
Disassembly/Reassembly
6)
6)
8)
7)-1
FEEDER ASSY
If your screwdriver is not long enough to perform the following work, close the COVER
C H E C K
P O I N T
ASSY FRONT for easier operation.
6. Remove the two screws (silver, self-tapping, 10 mm) that secure the FEEDER ASSY to the main unit.
Be careful not to drop the SPRING EARTH on the right side of the FEEDER ASSY.
7. Pull out the protrusion on the left side of the FEEDER ASSY, slide the FEEDER ASSY slightly to the
far left side, and pull out the two protrusions (one is attached the SPRING EARTH) on the right side
from the main unit.
Make sure that the SPRING EARTH attached to the right side of the FEEDER ASSY
touches the PLATE EARTH of the main unit.
8. Pull out the shaft and the clutch on the right side of the FEEDER ASSY from the main unit, and
remove the FEEDER ASSY from the main unit.
Be careful not to lose the SPRING EARTH attached on the right side of the FEEDER ASSY.
Revision C
7)-2
Kmy03028EA
7)-2
Confidential
250