Epson AcuLaser C2800 Service Manual page 238

AcuLaser C2800/C2800D/C3800/C3800D
A
4) (Black)
6) (White)
3)
3)
7) (Long, Yellow)
5) (White)
1. Remove the E-rings that secure the ROLL REGI METAL and the shaft of the ROLL REGI RUBBER.
2. Remove the BEARING REGIs (black) that secures the ROLL REGI METAL and the shaft of the
ROLL REGI RUBBER.
3. Remove the E-rings that secure the ROLL REGI METAL and the shaft of the ROLL REGI RUBBER.
4. Remove the GEAR REGI METAL (black) attached to the shaft of the ROLL REGI METAL.
5. Remove the GEAR REGI RUBBER (white) attached to the shaft of the ROLL REGI RUBBER.
6. Remove the BEARING REGIs (white) that secures the ROLL REGI METAL and the shaft of the
ROLL REGI RUBBER.
7. Remove the SPRING REGI R, L from the BRACKET NIP.
8. Remove the BRACKET NIP as shown in the figure.
DISASSEMBLY/REASSEMBLY
ROLL REGI METAL
ROLL REGI RUBBER
8)
7) (Short, Metallic color)
1)
1)
2) (Black)
Kmy03211EA
NEXT>>
Disassembly/Reassembly
9)
10)
9. Temporarily slide the ROLL REGI METAL toward right, pull out the left end of the ROLL REGI
METAL from the CHUTE REGI, and remove the ROLL REGI METAL.
10. Temporarily slide the ROLL REGI RUBBER toward right, pull out the left end of the ROLL REGI
RUBBER from the CHUTE REGI, and remove the ROLL REGI RUBBER.
Install the short metallic-colored SPRING on the right and the long yellow SPRING on
the left as shown in the figure. (Step 7)
Install the two black BEARINGs on the right and the two white BEARINGs on the left
as shown in the figure. (Step 2 and 6)
Install the white GEAR on the near side and the black GEAR on the far side as shown in
the figure. (Step 4 and 5)
Revision C
ROLL REGI METAL
ROLL REGI RUBBER
Kmy03212EA
238
Confidential