Epson AcuLaser C2800 Service Manual page 356

AcuLaser C2800/C2800D/C3800/C3800D
7)
4. Release the two tabs of the FRANGE PULLEY UP with a mini screwdriver or a similar tool, and
remove the FRANGE PULLEY UP from the PULLEY DUP.
5. Remove the BELT DUP from the PULLEY DUP.
6. Release the tab, and remove the PULLEY DUP from the shaft of the ROLL ASSY DUP-1.
7. Remove the BEARING DUPs that secure the left and right ends of the ROLL ASSY DUP-1 by
rotating them in the direction of the arrow.
8. Temporarily slide the ROLL ASSY DUP-1 toward left, pull out the right end of the ROLL ASSY
DUP-1 from the FEEDER ASSY DUP, and remove the ROLL ASSY DUP-1.
DISASSEMBLY/REASSEMBLY
ROLL ASSY DUP-1
6) 4)
8)
5)
Kmy03229EA
Disassembly/Reassembly
D
6)
6)
6)
7)
4)
4)
1. Release the four tabs that secure the COVER HARNESS CHUTE, and remove the COVER
HARNESS CHUTE.
2. Disconnect the connector (P/J427) of the FAN DUP on the PWBA DUP-H.
3. Loosen the two clamps that secure the harness of the FAN DUP to the FEEDER ASSY DUP, and
remove the harness.
4. Remove the two screws (silver, self-tapping, 10 mm) that secure the BRACKET FAN DUP to the
FEEDER ASSY DUP.
5. Remove the BRACKET FAN DUP together with the FAN DUP from the FEEDER ASSY DUP.
6. Remove the two screws (silver, self-tapping, 10 mm) that secure the COVER HARNESS FAN to the
BRACKET FAN DUP, release the harness, and remove the COVER HARNESS FAN.
7. Release the four tabs that secure the FAN DUP to the BRACKET FAN DUP, and remove the FAN
DUP.
Install the FAN DUP so that its label is facing the FEEDER ASSY DUP.
FAN DUP
1) 3) 2)(J427)
5)
FAN DUP
Kmy03226EB
Revision C
7)
Label Side
356
Confidential