Toyota LAND CRUISER PRADO Owner's Manual page 668

◆
Registering ID codes
The tire pressure warning valve and transmitter is equipped with a
unique ID code. When replacing a tire pressure warning valve and
transmitter, it is necessary to register the ID code. When registering
the ID codes, perform the following procedure:
How to register the ID codes
■
Turn the engine switch to the "ON" position (vehicles without a
1
smart entry & start system) or IGNITION ON mode (vehicles with
a smart entry & start system).
Press the tire pressure warn-
2
ing reset switch briefly 3
times in succession.
The tire pressure warning light
blinks slowly 3 times.
The change wheel set mode is
activated and registration is
started.
Vehicles with the multi-informa-
tion display type B: "--" is dis-
played for inflation pressure of
each tire on the multi-informa-
tion display.
Then, the tire pressure warning
light blinks rapidly for approxi-
mately 1 minute and stays on.
Drive the vehicle at approximately 40 km/h (25mph) or more for
3
approximately 10 to 30 minutes.
Vehicles with the multi-information display type B: When registration is
completed, the tire pressure warning light will go off and the inflation
pressure of each tire will be displayed on the multi-information display.
The time elapsed before registration is completed differs according to
the driving condition and environment.
LC150_OM_OM60R93E_(GE)
7-3. Do-it-yourself maintenance
667
7