128
2. Instrument cluster
■
Pop-Up display (if equipped)
The pop-up display is displayed on the multi-information display according to
the operating conditions of the following functions:
Route guidance display of the navigation system-linked system (if equipped)
●
●
Incoming call display of the hands-free phone system (if equipped)
The pop-up display function can be disabled.
■
Tire inflation pressure (vehicles with the tire pressure warning system)
●
It may take a few minutes to display the tire inflation pressure after the
engine switch is turned to IGNITION ON mode. It may also take a few min-
utes to display the tire inflation pressure after inflation pressure has been
adjusted.
●
"---" may be displayed if the tire information cannot be determined due to
unfavorable radio wave conditions.
Tire inflation pressure changes with temperature. The displayed values may
●
also be different from the values measured using a tire pressure gauge.
■
Outside temperature display
In the following situations, the correct outside temperature may not be dis-
played, or the display may take longer than normal to change:
●
When the vehicle is stopped, or moving at low speeds (less than 20 km/h
[12 mph])
When the outside temperature has changed suddenly (at the entrance/exit
●
of a garage, tunnel, etc.)
When "--" or "E" is displayed, the system may be malfunctioning. Take your
●
vehicle to Toyota dealer.
■
Suspension of the settings display
In the following situations, the settings display using the meter control
switches will be suspended.
●
When a warning message appears on the multi-information display
When the vehicle begins to move
●
■
Liquid crystal display
Small spots or light spots may appear on the display. This phenomenon is
characteristic of liquid crystal displays, and there is no problem continuing to
use the display.
LC150_OM_OM60R93E_(GE)