Toyota LAND CRUISER PRADO Owner's Manual page 403

402
4-5. Using the driving support systems
■ Cruise control can be set when
● The shift lever is in the D or range 4 or higher of S has been selected (vehi-
cles with an automatic transmission).
● Vehicle speed is above approximately 40 km/h (25 mph).
■ Accelerating after setting the vehicle speed
The vehicle can be accelerated normally. After acceleration, the set speed
●
resumes.
● Even without canceling the cruise control, the set speed can be increased
by first accelerating the vehicle to the desired speed and then pushing the
lever down to set the new speed.
■ Automatic cruise control cancelation
Cruise control will stop maintaining the vehicle speed in any of the following
situations:
Actual vehicle speed falls more than approximately 16 km/h (10 mph) below
●
the preset vehicle speed.
At this time, the memorized set speed is not retained.
● Actual vehicle speed is below approximately 40 km/h (25 mph).
VSC is activated.
●
● TRC is activated for a period of time.
● When the VSC or TRC system is turned off.
Switching operation to center differential lock mode continues for 5 seconds
●
or more after operating the center differential lock/unlock switch.
■ If "Cruise Control Malfunction Visit Your Dealer" is shown on the multi-
information display or the cruise control indicator light turns to yellow
Press the "ON-OFF" button once to deactivate the system, and then press
the button again to reactivate the system.
If the cruise control speed cannot be set or if the cruise control cancels imme-
diately after being activated, there may be a malfunction in the cruise control
system. Have the vehicle inspected by your Toyota dealer.
LC150_OM_OM60R93E_(GE)