Extremeswitching X440-G2-12P-10Ge4 Switch Ports And Slots - Extreme Networks ExtremeSwitching X435 Series Hardware Installation Manual

ExtremeSwitching Switches
Figure 15: ExtremeSwitching X440-G2-12t-10GE4 Rear Panel
1 = Redundant power input
2 = Grounding lug

ExtremeSwitching X440-G2-12p-10GE4 Switch Ports and Slots

The ExtremeSwitching X440-G2-12p-10GE4 switch ports and slots include:
•
12 front panel PoE+ ports of 10/100/1000BASE-T. Both half-duplex and full-duplex communication
are supported on all 12 ports.
•
Four unpopulated 1GBASE-X SFP+ ports that can be used as either 1Gb ports or 10Gb ports, where
the 10Gb configuration requires an upgrade through additional licensing.
Alternately, you can convert two of the ports to stacking ports using the enable stacking-
support command. Doing so would provide you with the option of two 1Gb ports and two stack
ports or two 10Gb ports and two stack ports. In the latter configuration, an additional license would
be required for the 10Gb non-stacking ports.
•
Ethernet management port (10/100/1000BASE-T).
•
Serial console port implemented as an RJ45 connector used to connect a terminal and perform local
management.
•
One front panel USB 2.0 port, operational on switches running ExtremeXOS version 22.2 or later.
•
One rear redundant power supply connector.
Figure 16: ExtremeSwitching X440-G2-12p-10GE4 Front Panel
ExtremeSwitching X440-G2-12p-10GE4 Switch Ports
3 = AC power input socket
ExtremeSwitching Hardware Installation Guide
and Slots
33