Single-Step Feed - Mitsubishi Electric MELSERVO-J2-Super Series Instruction Manual

7. SERVO CONFIGURATION SOFTWARE

7.7.5 Single-step feed

Operation is performed in accordance with the preset point table No.
Click "Test" on the menu bar and click "Single-step Feed" on the menu.
Clicking displays the following window.
Since this window shows the precaution for use of the MR-J2S-B, click the "OK" button.
When the above choices are made, the following window appears:
a)
POINT
The servo motor will not operate if the forced stop (EMG), forward
rotation stroke end (LSP) and reverse rotation stroke end (LSN) are off.
Make automatic ON setting to turn on these devices or make device
setting to assign them as external input signals and turn on across these
signals and SG. (Refer to Section 7.6.)
b)
c)
d)
7 - 18