Operation; Display; During Operation; During Regeneration - Pentair Riversoft Installer Manual

7.

Operation

7.1.

Display

7.1.1. During operation

• The current time in 24 hours is displayed on 2 digits
(minutes are not displayed).
• The flow indicator blinks ON and OFF when water is flowing.

7.1.2. During regeneration

• The controller will display a cascading symbol "--" until
regeneration is complete.
• If a button is pressed the current time and cycle will be
displayed alternately.
7.2.

Manual regeneration

MANDATORY
The controller must be in service in order to enable this procedure.
NOTE

The unit returns to normal operation if no buttons are pressed within 30 seconds.

7.2.1. Manual delayed regeneration

A Press once for delayed regeneration.
→ The regeneration will start on the scheduled time. See chapter 5.1. Display, page 44.
→ The regeneration dot will blink when delayed regeneration is on.
NOTE

To cancel: press
Ref. MKT-IM-045 / A - 13.03.2020

again. The regeneration dot disappears.
Installer Manual Riversoft - Operation
55 / 90