Table of Contents
Advertisement
Problem Solving
Problems when Projection Starts
The projector does not turn on
Check
Is the main power switch set to Off?
Did you press the [
] button on the remote control or control
panel?
Are the indicators switched off?
Do the indicators turn on and off when the power cord is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If this
Is the Control Panel Lock set to Full Lock?
Is the correct setting for the remote receiver selected?
Was the power cord plugged back in or was the breaker turned on
immediately after direct shutdown?
Is the [ID] switch on the remote control set to On?
Turn on the main power switch to supply power to the projector.
Press the [
] button to turn on the power.
The power cord is not connected correctly or power is not being supplied.
Disconnect and then reconnect the power cord.
Check that your electrical outlet or power source is functioning correctly.
does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
Press the [
] button on the remote control. If you do not want to use Control Panel Lock, change the setting to
Off.
s "Control Panel Lock"
p.117
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver
p.145
If the operation described in the column on the left is performed when Direct Power On is set to On, the power may not
turn back on. Press the [
] button to turn on the power.
When the switch is set to On, you can use the remote control to operate only a projector with a matching ID. Set the [ID]
switch to Off.
s "Setting the remote control ID"
p.44
Remedy
208
Advertisement
Table of Contents
