Multi-Projection Function
a
Select Screen Matching from Multi-Projection, and then press
the [
] button.
b
Select Start Auto Adjustment, and then press the [
When a message is displayed, select Yes. The adjustment pattern is
displayed, and adjustment starts. If the projected image is displayed
before the adjusting, the procedure is complete.
a
See the following if an error occurs.
s "Automatic adjustments are not performed correctly"
To return to the status before auto adjustment, select Undo. When
you select Redo after selecting Undo, it returns the image to the
status after auto adjustment.
If the amount of blend width or lens shift is too large, blend curve
may not be corrected properly. Adjust the Blend Curve manually.
s "Edge Blending"
To return Screen Matching to its default value, select Reset.
p.91
Color Matching
You can fine tune the color balance and brightness from black to white for
each color tone.
] button.
When the projectors are not connected to a network, or if you want to
adjust manually after the automatic adjustments, perform the following
steps on all projectors.
a
We recommend that you reset the following settings on the Image
menu to display the adjustment screen at the appropriate brightness
and color.
Brightness
Contrast
Color Saturation
Tint
White Balance (Color Temp., G-M Correction, Offset R, Offset G,
Offset B, Gain R, Gain G, Gain B)
Gamma
RGBCMY
a
Select Screen Matching from Multi-Projection, and then press
the [
p.206
b
Select Color Matching, and then press the [
] button.
97
] button.