Cannot Control Correctly Using Art-Net; Nothing Appears On The External Monitor - Epson EB-L30002U User Manual

Problem Solving
Check
Is the remote control button lock set?

Cannot control correctly using Art-Net

Check
While controlling the projector using Art-Net, did you operate
the projector using the remote control or control panel?

Nothing appears on the external monitor

Check
Is the external monitor connected to the correct port?
Are you projecting a split screen?
Is the projector in standby status?
When the remote control button lock is set, buttons except for those needed for basic remote control operations are
deactivated. Hold down the [ ] button to cancel the remote control button lock.
s "Remote control button lock" p.118
While controlling the projector using Art-Net and performing operations from the remote control or control
panel, settings made by the DMX controller or application software may not be applied to the projector
correctly. When you want to apply all the channel controls to the projector, set Channel 13 to "Cannot
control", then set it back to "Can control".
s "About Art-Net" p.246
The port to which the external monitor should be connected varies depending on the port to which the image
you want to display is being input.
 When inputting an image signal to the Computer port or the BNC port, connect to the Monitor Out
port.
 When inputting an image signal to the 3G/HD/SD SDI port, connect to the Monitor Out SDI port.
Only RGB signals projected on the left screen from the Computer port or the BNC port can be displayed on an
external monitor.
s "Projecting Two Images Simultaneously (Split Screen)"
Check that A/V Output and Monitor Out from the Configuration menu are set correctly.
s Extended - A/V Settings p.147
Remedy
Remedy
Remedy
p.103
210