Other Problems; There Are Afterimages (Screen Burn-In) In The Projected Image; The Remote Control Does Not Work - Epson EB-L30002U User Manual

Problem Solving

Other Problems

There are afterimages (screen burn-in) in the projected image

Check
Have you been projecting a still image or an image that does not
move much for a long time?

The remote control does not work

Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Is the correct setting for the Remote Receiver selected?
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.
Are the remote control ID and the projector ID matched?
Is the optional remote control cable connected to the projector's
Remote port?
Is Control Communications or Extron XTP set to On?
You can remove afterimages (screen burn-in) from the projected image by using Refresh Mode. Select Start from
Refresh Mode in the Reset menu.
s Reset - Refresh Mode p.163
Point the remote control towards the remote receiver.
s "Remote control operating range"
Check the operating range.
s "Remote control operating range"
Set the projector up in a location where strong light does not shine onto the remote receiver.
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.145
s "Replacing the remote control batteries"
Make sure the ID for the projector you want to operate and the ID for the remote control match. To operate all projectors
by remote control regardless of the ID setting, set the [ID] switch on the remote control to Off.
s "ID Settings" p.43
When the remote control cable is connected, the projector's remote receiver is disabled. When not using the remote
control cable set, disconnect it from the Remote port.
The Remote port is disabled. When using the optional remote control cable set, set Control Communications or Extron
XTP to Off.
s Extended - HDBaseT p.147
Remedy
Remedy
p.27
p.27
p.26
209