The Image Is Truncated (Large) Or Small, The Aspect Is Not Suitable, Or The Image Has Been Reversed - Epson EB-L30002U User Manual

Problem Solving
Check
Is the Sync./Tracking adjusted correctly?
(Only when projecting computer images)
Is the Resolution set to anything other than Auto?
(Only when projecting on a split screen)

The image is truncated (large) or small, the aspect is not suitable, or the image has been reversed

Check
Have the Screen been set correctly?
Is the aspect adjusted correctly?
Is a wide panel computer image being projected?
(Only when projecting computer images)
Is Scale turned on?
Is the display range restricted by Blanking?
Is the image position adjusted correctly?
Is the computer set for dual display?
(Only when projecting computer images)
Press the [Auto] button to perform automatic adjustment. If the images are not adjusted correctly even after performing
automatic adjustment, you can also make adjustments from the Configuration menu.
s Signal - Tracking, Sync. p.143
The image may be collapsed if the Resolution on the Configuration menu and the resolution of the projected image are
not the same.
If the image is collapsed, set the Resolution to Auto.
s Signal - Resolution p.143
Make the appropriate Screen for the screen being used.
s "Screen Settings" p.34
Press the [Aspect] button to select an aspect suitable for the input source.
s "Changing the Aspect Ratio of the Projected Image"
Change the setting according to the signal for the connected equipment.
s Signal - Resolution p.143
Set Scale to Off on the configuration menu.
s Signal - Scale - Scale p.143
Appropriately set Blanking in the configuration menu.
s Signal - Blanking p.143
(Only when projecting analog RGB signals input from the Computer port)
Press the [Auto] button to adjust the display position.
You can also adjust the position from the Configuration menu.
s Signal - Position p.143
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver's documentation
Remedy
Remedy
p.78
204