Table of Contents
Advertisement
Batch Setup
Setup Using a USB Flash Drive
This section explains how to perform batch setup using a USB flash drive.
a
Use a FAT format USB flash drive.
The batch setup function cannot be used by USB flash drives that
incorporate security functions. Use a USB flash drive that does not
incorporate security functions.
The batch setup function cannot be used by USB card readers or
USB hard disks.
Saving settings to the USB flash drive
a
Turn off the main power switch while the power cord is connected
to the projector, and check that all of the projector's indicators
turn off.
b
Connect the USB flash drive to the projector's USB-A port.
"Installing the Wireless LAN Unit"
s
p.55
a
Connect the USB flash drive directly to the projector. If the
USB flash drive is connected to the projector through a USB
hub, the settings may not be saved correctly.
Connect an empty USB flash drive. If the USB flash drive
contains data other than the batch setup file, the settings may
not be saved correctly.
If you have saved a batch setup file from another projector to
the USB flash drive, delete the file or change the file name.
The batch setup function cannot overwrite a batch setup file.
The file name for the batch setup file is PJCONFDATA.bin. If
you need to change the file name, add text after
PJCONFDATA. If you change the file name in any other way,
the projector may not be able to recognize the file correctly.
You can only use single-byte characters for the file name.
c
While holding down the [Esc] button, turn on the main power
switch.
166
Advertisement
Table of Contents
