Correcting Distortion (Image Warping) - Epson EB-L30002U User Manual

Installing the Projector
a
 You can also use the [Focus] buttons ([+] and [-]) on the remote
control to adjust the focus.
 When projecting from several projectors and there is a difference in
brightness, we recommend displaying the grayscale test pattern and
adjusting the focus.
 If the focus is not correct even after adjusting the focus, hold down
the [Default] button on the remote control for about three seconds
to perform lens calibration. When lens calibration is complete, adjust
the focus again.

Correcting Distortion (Image Warping)

When using the ELPLR05 or ELPLU05 and focusing at the center of the
screen, the surrounding image may warp and be out of focus. Follow the
steps below to correct the warping.
a
Press the [Focus/Distortion] button on the control panel.
Press repeatedly until the focus adjustment screen is displayed.
b
Press the [ ][ ] buttons to focus the image around the center of
the lens.
c
Press the [Focus/Distortion] button on the control panel again.
Press repeatedly until the distortion adjustment screen is displayed.
d
Press the [ ][ ] button to adjust the focus of the surrounding
area.
If the center is out of focus after adjusting the surrounding image,
repeat steps 1 to 2.
41