Epson EB-L30002U User Manual page 4

Safety Warning and Cautions
Warning
 Do not cover the projector'sair intake vent or air exhaust vent. If either of the
vents is covered, the internal temperature could rise and cause a fire.
 Make sure you secure the following space around the projector so as not to
block the air intake vent and air exhaust vent.
500mm
 When setting up multiple projectors, make sure there is a gap of at least 200
mm between the projectors. Also, make sure that the heat from the air
exhaust vent does not go into the air intake vent.
 When installing the projector with the air intake vent facing down, make sure
there is a gap of at least 100 mm between the projector and the floor and so
on. Make sure there is a space of 800 x 350 mm for the base so that the air
intake vent is not blocked.
100mm
500mm
500mm
200mm
800mm
350mm
Caution
Do not place the projector on an unstable surface, such as on an unstable table
or tilted surface. Install the projector appropriately to prevent the projector
from falling.
Otherwise it may cause an injury.
Attention
 Do not install the projector in a location that is subject to vibration or
shock.
 Do not install the projector near a high-voltage line or object that generates
magnetism. Otherwise the projector may not work correctly.
 Do not use or store the projector in a location that is subject to extreme
temperatures. Also, avoid sudden temperature changes.
Make sure you use or store the projector in a place that is within the
operating or storage temperature ranges.
s "Projector General Specifications"
 Do not install the projector in direct sunlight.
If the projector is in direct sunlight, the internal temperature increases, which
could cause parts such as the surface of the projection lens or the built-in
camera to deteriorate.
 When installing the projector in an environment in which a high-powered
laser beam is being used, make sure it is installed so that the laser beam does
not hit the surface of the projection lens.
 When using at an altitude that exceeds 1,500 m, set High Altitude Mode to
On.
s Extended - Operation - High Altitude Mode
p.270
p.147
4