Table of Contents
Advertisement
List of Functions
Submenu
Projector Info
Operation
Hours
Source
Input Signal
Resolution
Refresh Rate
Sync Info
Color Format
Status
Serial Number
Function
Displays the operation time after turning on
the projector.
You can display the source name for the
connected equipment currently being
projected.
You can display the content of Input Signal set
in the Signal menu according to the source.
You can display the resolution.
You can display the Refresh Rate.
You can display the image signal information.
This information may be needed if service is
required.
Displays color space and dynamic range
information.
This is information about errors that have
occurred on the projector.
This information may be needed if service is
required.
Displays the projector's serial number.
Submenu
Lens Type
Event ID
HDBaseT Signal
Level
Light Source
Light Source
Info
Hours
Estimated Re‐
mains
Version
Main
Video2
Sub
Sub2
HDMI
HDBaseT
HDBaseT2
SDI
Status Monitor
AC Monitor
Status Information
Function
Displays the model number of your lens.
When problems occur when the projector and
computer are connected through the network,
information on the problem is displayed using
an Event ID. See the following page for
information on interpreting the Event ID.
s "About Event ID"
p.213
Displays the level for the image signal being
input from the HDBaseT port. When this is
displayed in yellow, the strength of the signal
level is reduced. We recommend the following
signal levels.
1080p: 16 dB or more
4K: 18dB or more
Displays the operating time for the light source
according to the light source mode.
When Constant Brightness is set to On, this
displays the amount of time for which the
brightness of the light source can be
maintained.
Displays the versions of the projector's
software and the devices connected to the
projector.
Displays the projector's status.
s "Understanding the Status Information"
p.182
162
Advertisement
Table of Contents
