Table of Contents
Advertisement
Problem Solving
Automatic adjustments are not performed correctly
Check
Have at least 20 minutes passed since the power was turned on?
Is the cover of the built-in camera clean?
Is an analog signal being input?
Has the image been corrected using Geometry Correction?
Is the brightness of the surroundings appropriate?
Is the blending width 15 to 45%?
Problems when Projection Starts
The projector does not turn on
Check
Is the main power switch set to Off?
Did you press the [
] button on the remote control or control
panel?
Are the indicators switched off?
Auto adjustment does not work correctly until the temperature of the projector is stable. Perform auto adjustment 20
minutes after turning on the projector or canceling Shutter.
Make sure that the cover of the built-in camera is clean. Clean the cover if it is dirty.
When inputting an analog signal, the color and brightness of the input image changes, and the results of adjustment may
not be applied correctly.
Auto adjustment may not work for images corrected using Geometry Correction. Set Geometry Correction to Off or
reduce the correction range.
s Settings - Geometry Correction
p.123
If a powerful spotlight or natural light shines into the area during auto adjustment, the brightness of the surroundings
changes and auto adjustment does not operate correctly. Make sure the brightness of the surroundings does not change.
If the blending width in Edge Blending is 15% or less, or 45% or more, the Screen Matching function may not operate
correctly. Check the blending width.
s Extended - Multi-Projection - Edge Blending
Turn on the main power switch to supply power to the projector.
Press the [
] button to turn on the power.
The power cord is not connected correctly or power is not being supplied.
Disconnect and then reconnect the power cord.
Check that your electrical outlet or power source is functioning correctly.
Remedy
p.125
Remedy
169
Advertisement
Table of Contents
