Problems When Projection Starts; Problems With The Remote Control - Epson EH-TW5950 User Manual

Table of Contents

Advertisement

Troubleshooting

Problems when projection starts

The projector does not turn on
Check
Is the power turned on?
Is Child Lock set to On?
Is Control Panel Lock set to On?
Are the indicators switched off?
Do the indicators turn on and off when the
power cable is touched?

Problems with the remote control

The remote control does not respond
Check
Is the remote control light-emitting area
pointing towards the remote receiver on the
projector during operation?
Is the remote control too far from the projec-
tor?
Is direct sunlight or strong light from fluores-
cent lamps shining onto the remote receiver?
Are the batteries dead or have the batteries
been inserted correctly?
Is the remote control pointed at the Wire-
lessHD Transmitter when operating the WiHD
Transmitter control button? (EH-TW6100W
only)
Press the
button on the remote control or the
on the control panel.
When Child Lock is set to On from the configuration menu, hold
down the
button on the control panel for approximately
three seconds, or perform operations from the remote control.
Settings - Lock Setting - Child Lock
s
If Control Panel Lock is set to On from the configuration menu,
all of the control panel buttons except for
bled. Perform operations from the remote control.
- Lock Setting - Control Panel Lock
Disconnect and then reconnect the projector's power cable.
Check that power is being supplied.
Turn off the projector, and then disconnect and reconnect the
projector's power cable. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
Epson Projector Contact List
center.
s
Point the remote control towards the remote receiver. Also,
check the operating range.
Check the operating range.
Set the projector up in a location where strong light does not
shine onto the remote receiver.
Make sure the batteries are inserted correctly or replace the bat-
teries with new ones if necessary.
Make sure you point the remote control at the WirelessHD Trans-
mitter when using the WiHD Transmitter control button on the
remote control.
p.55
s
84
Remedy
p.71
button are disa-
s
p.71
Remedy
p.21
s
p.21
s
p.21
s
button
Settings

Advertisement

Table of Contents
loading

Table of Contents