Baxi POWER HT+ Series Installation And Service Manual page 76

9 Settings
P P arameter number
Heating Heating Heating
circuit 1 circuit 2 circuit 3
760 1060 1360
809 1109 1409
834 1134 1434
850 1150 1450
851 1151 1451
855 1155 1455
856 1156 1456
Tab.46 Menu T T emps / mode hot water
Parameter Parameter
number
1600 O O perating mode
1610 H H ot water temp
setpoint
1612 R R educed temp
setpoint
1620 R R elease
76
Parameter Description
R R oom temp Cuts the heating circulation pump if the room T
limitation ° exceeds the current set point + parameter
760, 1060, 1360
C C ontinuous pump No : The heating circuit / boiler pump may be
operation shut down during an accelerated decline in
temperature or when the room temperature
set point is reached.
Yes : The heating circuit / boiler pump also
continues to run during the accelerated de­
cline in temperature and when the room tem­
perature set point is reached.
A A ctuator running Setting the stroke of the servomotor on the
time mixing valve used
F F loor curing Controlled screed-drying function:
function Off : The function is inoperative.
Curing/functional heating : Active for 7 days,
3 days at a T° of 25°C and 4 days at a T° of
55°C
Curing heating : Active for 18 days, 6 days
from 25°C to 55°C increasing by 5°C a day,
6 days at a T° of 55°C, 6 days from 55°C to
25°C diminishing by 5°C a day.
Functional/curing heating : First, "Functional
Heating" cycle, and then, "Ready for Occu­
pation".
Functional heating : First, "Ready for Occu­
pation" cycle, and then, "Functional Heating".
Manually : Regulation is based on the "Man­
ual Control Drying" set point.
F F loor curing setp The flow temperature set point of the "Manual"
manually controlled drying function can be set separately
for each heating circuit.
F F loor curing setp Displays the current day of the controlled
current screed-drying function. With ' ---' the function is
deactivated.
D D ays Displays the current flow temperature set point
complete.current of the controlled screed-drying function. With
' ---' the function is deactivated.
Description
Off Permanent running on the antifreeze set point
On DHW loading is done automatically at the nominal set point
EcoThe temperature maintenance function is deactivated
DHW set point during release times
Reduced set point outside release times
Start-up enabled:
Time hot water : This setting provides DHW preparation with a
dedicated timer program.
Time setting central heating : The release of DHW is done in //
of the period of occupation of the heating circuits.
24h/day : Default setting for instantaneous boilers.
Unit Factory set­
ting
°C 0 0 .5
– no
seconds 30
S O O ff
°C 25
- '---'
- '---'
Factory setting
On
6 6 0°C
3 3 5°C
Time hot water
7609474 - v02 - 04092014