Fig.54
Pressing down the spring
1
Fig.55
Connecting the wire
7609474 - v02 - 04092014
Neutral operating conditions.
Tab.18 Specifications of the power cable and the power source
Cable cross section (mm²)
C DJ curve (circuit breaker)
6 6 .6.3 Accessing the terminal blocks
1. Remove the front panels.
6.6.4 Wiring the terminal blocks
Use a flat-bladed screwdriver less than 3.5 mm in width.
1. Press down the spring on the terminal block with a suitable screw
MW-3000037
2. Insert the stripped part of the wire into the corresponding connector.
2
MW-3000038
See
Accessing the internal boiler components, page 37.
driver.
Caution
The length to be stripped must be between 10 and 12 mm.
6 Installation
3 x 1.5
10 A
49