Starting Up The Boiler; Stopping The Boiler; Putting The Boiler In Standby Mode - Baxi POWER HT+ Series Installation And Service Manual

Fig.73
----------------------------------------------------
Enduser
Commissioning
Fig.74
Enduser
Commissioning
Engineer
8.2

Starting up the boiler

Fig.75 Starting up the boiler
1
8.3

Stopping the boiler

7609474 - v02 - 04092014
MENU
MW-3000083-EN-02
MENU
MW-3000084-EN-02
MW-3000050
3. Select the C C ommissioning menu by turning the
4. Confirm the menu selection by pressing the button
Note
Press the key to return to the main display.
MENU
The C C ommissioning mode parameters are now accessible. Use the
button to select and modify them.
See
List of installer parameters, page 74.
1. Start up the boiler by pressing the ON/OFF switch.
2. Open the gas cock.
3. Press the key to access the shortcuts menu.
4. Select the S S tandby/operation parameter by turning the
5. Press the button to start up the boiler.
The symbol disappears.
Note
Prefer the O O ff or S S tandby operating mode.
See
Activating Protection mode, page 70
Putting the boiler in Standby mode, page 69
1. Switch off the boiler by pressing the ON/OFF switch.
2. Close the gas cock.

8.3.1 Putting the boiler in Standby mode

1. Press the key to access the shortcuts menu.
2. Select the S S tandby/operation parameter by turning the
3. Press the button to put the boiler in standby.
The symbol is displayed.
8 Operation
button.
.
button.
button.
69