Baxi POWER HT+ Series Installation And Service Manual page 75

Tab.44 Menu W W ireless
Parameter Parameter
number
120 B B inding
121 T T est mode
130 R R oom unit 1
131 R R oom unit 2
132 R R oom unit 3
133 O O utside temperature
sensor
134 R R epeater
135 I I n operation
140 D D elete all devices
Tab.45 Menus T T emps / mode CH1 – T T emps / mode CH2 – T T emps / mode CH3
Parameter number
Heating Heating Heating
circuit 1 circuit 2 circuit 3
714 1014 1314
720 1020 1320
730 1030 1330
732 1032 1332
740 1040 1340
741 1041 1341
742 1042 1342
746 1046 1346
750 1050 1350
7609474 - v02 - 04092014
Description
Activation of wireless connection with the base unit.
The test mode is used to check the wireless communication.
Checking the link.
Checking the link.
Checking the link.
Checking the link.
Checking the link.
Checking the link.
Deletes all appliances
Parameter Description
F F rost protection
setpoint
H H eating curve Heating curve gradient: The regulator calcu­
slope lates the flow T° set point which is used for the
control system, according to outside weather
conditions.
S S ummer/winter Limit temperature for Heating/Frost Protection
heating limit Mode switching. Triggers or shuts down the
heating in the course of the year according to
variations in outside T°. This switch is made
automatically in Automatic mode.
2 2 4-hour heating The heating is shut down when the outside T°
limit is equal to the room temperature + parameter
732 (deactivated in Comfort mode).
F F low temp The flow set point calculated is limited by the
setpoint min set value.
F F low temp The flow set point calculated is limited by the
setpoint max set value.
F F low temp The set flow value is applied in room tempera­
setpoint room stat ture thermostat mode. ' ---' the boiler is running
in modulation mode.
D D elay heat
request
R R oom influence Influence of the room T° and the outside T°
on calculating the flow temperature: ---%:
Simple regulation in accordance with outside
weather conditions
1...99%: Regulation in accordance with out­
side weather conditions with room tempera­
ture influence.
100%: Regulation in accordance with the
room temperature only.
9 Settings
Unit Factory set­
ting
°C 6
– Heating
circuit 1:
1.5
Heating
circuit 2:
0.7
Heating
circuit 3:
0.7
20
°C 0
°C 25
°C 80
°C 80
% 50
75