List Of Installer Parameters - Baxi POWER HT+ Series Installation And Service Manual

9 Settings
Tab.42 Menu T T emps / mode CH1 – Temps / mode CH2 – Temps / mode CH3
Parameter number
Heating Heating Heating cir­
circuit 1 circuit 2 cuit 3
700 1000 1300
710 1010 1310
712 1012 1310
Tab.43 Menu O O perator section
Parameter Parameter
number
24 L L ighting
29 U U nits
40 U U sed as
42 A A ssignment device
1
43 A A ction operation
54 R R eadjustment room
sensor
70 S S oftware version
74
Parameter Description
The control unit is installed on the boiler:
Off: heating is deactivated.
Timed: heating is dependent on the hourly pro­
gram.
Reduced: heating is in permanent reduced mode.
On: heating is in permanent comfort mode.
The control unit is installed as a room temperature
Operating control system:
mode Off: the boiler starts up when the room tempera­
ture falls below the frost protection set point.
Timed: heating is dependent on the hourly pro­
gram.
Reduced: the room temperature set point is the
reduced set point (parameters 712, 1010, 1310)
On: the room temperature set point is the comfort
set point (parameters 710, 1010, 1310)
Comfort
setpoint
Reduced
temp setpoint

9.1.4 List of installer parameters

Description
Off
Temporarily
Permanently
°C, bar
°F, PSI
Operator unit 1 : The control system unit is installed on the boiler.
Room unit 1 : The control system unit is configured as a room tem­
perature appliance for heating circuit 1.
Room unit 2 : The control system unit is configured as a room tem­
perature appliance for heating circuit 2.
Room unit 3 : The control system unit is configured as a room tem­
perature appliance for heating circuit 3.
Like Room Temperature Unit 1, the action of the control system unit
can be assigned to CC1 or to two heating circuits:
Temps / mode CH1
Central heating 1 and 2
Central Heating 1 and 3
All central heatings
Locally : The room temperature appliance only controls the respec­
tive heating circuit.
Centrally : Only room temperature appliance 1 can be centralised. It
also controls the domestic hot water and standby mode.
-3°C to +3°C
Factory setting
On
20°C
16°C
Factory set­
ting
Temporarily
°C, bar
Operator unit
1
All central
heatings
Centrally
0°C
7609474 - v02 - 04092014