Agilent Technologies MSD 5977B Series Operating Manual page 69

3 Installing Intuvo 9000 GC Columns
To Replace the 9000 GC/MS Tail
4 Open the analyzer chamber. (See
5 If present, unscrew the knurled tip seal retainer and remove it, the interface
6 Ensure the MSD is properly aligned with the GC. If the GC and MSD are not
7 Open the GC front door.
8 Open the bus door and remove it by lifting the door vertically off its hinge
9 Using the Intuvo torque driver, remove the compression bolt that secures the
Thumb screw
MS tail heater assembly clamp
Compression bolts
Figure 14.
10 Open the MS tail heater assembly by loosening the thumb screw at the top of
11 Push the MS tail heater assembly back a few millimeters. A magnet will hold
5977B Series MSD Operating Manual
page 176.)
tip seal, and spring from the GC/MSD interface. (See
seal" on page 75.)
properly aligned, the transfer line clamp screw will be difficult to tighten.
pins.
9000 GC/MS Tail click and run bus connection. Also remove the bolt from the
empty bus connection. (See
MS tail heater assembly clamp closed
the clamp and rotating the clamp down.
the heater assembly away from the 9000 GC/MS Tail.
"To Open the Analyzer Chamber"
Figure 14.)
on
"GC/MSD interface tip
69