W20, Raw Water Connection From The Bottom; W34, Heat Exchanger Module Prepared For Installation On The Left In The Cabinet Lineup - Siemens SINAMICS S120 Manual
Cabinet modules liquid cooled
Hide thumbs
Also See for SINAMICS S120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
Options
9.51 W20, raw water connection from the bottom
9.51
W20, raw water connection from the bottom
Availability of option
This option is available for the following S120 Cabinet Modules:
● Heat Exchanger Modules
Description
The plant-side raw water is fed into the Heat Exchanger Module from above as standard.
With option W20, the plant-side raw water connection in the Heat Exchanger Module is at
the bottom.
The piping system is manufactured out of V2A stainless steel.
9.52
W34, Heat Exchanger Module prepared for installation on the left in
the cabinet lineup
Availability of option
This option is available for the following S120 Cabinet Modules:
● Heat Exchanger Modules
Description
With the option, a fixed pipe connection is routed downward on the right-hand side.
As a consequence, the Heat Exchanger Module can be installed at the left-hand end of the
drive lineup and connected to the deionized water circuit on the converter side. The
connecting parts (pipe couplings) are provided with the converter.
454
Cabinet Modules liquid cooled
Equipment Manual, 04/2020, A5E37067587A
Advertisement
Table of Contents
