12 SERVICE WORK ON THE CHASSIS
12.8
12.9
58
Installing the fork legs
A00451-11
A00468-11
A00467-11
Removing the lower triple clamp
F02398-10
Main work
–
Position fork legs.
1
Bleeder screws
are positioned toward the front.
Info
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
–
2
Tighten screws
.
Guideline
Screw, top triple
clamp
–
3
Tighten screws
.
Guideline
Screw, bottom triple
clamp
–
Position brake caliper. Mount and tighten screws
Guideline
Screw, front
M8
brake caliper
Finishing work
–
Install the front wheel.
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove front wheel.
(
–
Remove fork legs.
(
p. 57)
–
Remove front fender. (
Main work
–
1
Remove cable tie(s)
.
–
Allow the brake caliper and the brake line to hang loosely to
the side.
M8
15 Nm (11.1 lbf ft)
M8
17 Nm (12.5 lbf ft)
4
.
25 Nm (18.4 lbf ft)
Loctite
(
p. 101)
p. 55)
p. 101)
p. 66)
®
243™