KTM 450 Rally Factory Replica 2021 Owner's Manual page 124

18 SERVICE WORK ON THE ENGINE
122
–
Remove screw plug
rings.
S03046-10
–
Remove screw plug
rings.
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surfaces.
S03045-10
–
Mount and tighten screw plug
the O-rings.
Guideline
Screw plug, oil
screen
S03044-10
–
Position oil screen
–
Position the pin wrench through the drill hole of the screw plug
in the opposite section of the engine case.
–
Push the oil screen all the way into the engine case.
S03043-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil
screen
–
Mount and tighten oil drain plug
new seal ring.
Guideline
Oil drain plug with
S03042-10
magnet
2
with the short oil screen and the O-
3 4
with long oil screen
2
with the short oil screen and
M20x1.5 15 Nm (11.1 lbf ft)
4
with the O-rings on a pin wrench.
3
with the O-ring.
M20x1.5 15 Nm (11.1 lbf ft)
1
with the magnet and a
M12x1.5 20 Nm (14.8 lbf ft)
and the O-