8
8-4
2. Tighten the power supply captive screw on the back panel.
See Figure 8-3.
3. Connect the DC connector to the peripheral power cable at P1.
4. Route and insert the DC harness through the clip on the drive bracket.
5. Connect the DC connector on the system board at J2603.
6. Connect the DC connector on the system board at J2601.
Power supply
Captive screw
Back panel
Figure 8-3
Securing and Connecting the Power Supply
Sun Ultra 1 Series Service Manual—November 1995
P1
Clip
J2601
J2603