2. Remove the power supply as follows (
a. Using a No. 2 Phillips screwdriver, loosen the four captive screws securing the
power supply to the chassis.
b. Slide the power supply from the chassis rear until the power supply is stopped
by the power supply cables.
c. Disconnect the peripheral cable connector from the power supply
(not illustrated).
d. Disconnect the power supply cables from the motherboard (not illustrated).
e. Remove the power supply from the chassis.
Peripheral power cable
Power supply
(partially extended)
Captive screw (4)
Removing the Ultra 60 Power Supply
FIGURE 3-6
FIGURE 3-6
Chapter 3
Upgrading from an Ultra 30 or an Ultra 60 System
):
3-9