Figure 8-26 Speaker Connector on the System Board
8.7.2 Replacing the Speaker/LED Cable
1. Connect the speaker/LED cable to the system board at J2001, and route the
harness as shown. Secure the cable through the clips on the SCSI
backplane.
See Figure 8-26.
2. Replace any SBus card(s) you removed from slot 0 and/or 1.
See Section 10.3.2, "Replacing an SBus Card."
3. Connect the cable to the speaker with a long-nose plier.
See Figure 8-25. The speaker cable has two different connector sizes. These
connectors are keyed, to allow the correct connection to the speaker.
4. Route the speaker/LED cable through the two cable clips, and insert the
LED into the cavity.
See Figure 8-24. If you are replacing the LED itself, make sure the flat side of
the LED is lined up with the black wire.
Major Subassemblies
J2001
System board
Speaker/LED cable
8
8-29