8.7 Speaker/LED Cable
8.7.1 Removing the Speaker/LED Cable
Note – If the system does not contain a CD-ROM or a tape drive, go to Step 5.
1. Remove the two screws securing the drive bracket to the chassis.
See Figure 8-22.
Clip
Figure 8-22 Removing the Drive Bracket
2. Remove the DC harness from the clip located on the drive bracket.
See Figure 8-22.
3. Push the CD-ROM/tape drive bracket toward the disk drive bay, and
gently flip it over. Place it on top of the disk drive bay.
See Figure 8-23.
Major Subassemblies
8
Screws
8-25