Figure 8-1 Removing The Power Supply - Sun Microsystems Ultra 1 140 Service Manual

8
8.1 Power Supply
8.1.1 Removing the Power Supply
8-2
1. Disconnect the AC power cable from the system.
2. Disconnect the DC connector from the system board at J2603.
See Figure 8-1.
3. Disconnect the DC connector from the system board at J2601.
4. Remove the DC harness from the clip and disconnect the DC connector
from the peripheral power cable at P1.
Power supply
Captive
screw
Figure 8-1 Removing the Power Supply
Sun Ultra 1 Series Service Manual—November 1995
P1
Clip
DC harness
J2601
J2603