Removing The Software; Display Messages; If Your E-Mail Is Returned - Sharp MX-B201D Operation Manual

TROUBLESHOOTING

REMOVING THE SOFTWARE

In the event that you need to remove the printer driver or utilities, follow these steps:
Windows
1
Click the "start" button, and then click
"Control Panel".
On Windows 2000, click the "Start" button, select
"Settings", and then click "Control Panel".
2
Click "Add or Remove Programs".
• On Windows Vista/7, click the "Uninstall a
program".
• On Windows 2000, double-click the
"Add/Remove Programs" icon.

DISPLAY MESSAGES

If a transmission error occurs when you send a scanned image, a message informing you of the error and an error
code will appear in the operation panel on the machine.
Error Code
Turn off the power and turn it back on. Consult with your network administrator to make
CE-00
sure that no problems exist on the network or in the server. If the error is not cleared after
CE-01
turning the power off and on, turn off the power and contact your dealer.
Server access denied.
The scanned image was not sent because a connection to the server could not be established.
CE-02 Make sure that the SMTP server settings or FTP server settings in the Web page are correct.
CE-04 The procedure for configuring the SMTP server is explained in
SETTINGS", and the procedure for editing Scan to FTP destination information is
explained in
The scanned image was not sent because the server was busy or there was too much
CE-03
traffic. Wait briefly and then try again.
The scanned image was not sent because the directory of the destination FTP server was not
CE-05
correct. Make sure that the correct FTP server information is configured in the Web page.
The size of the scanned image file exceeds the upper limit set in "Maximum Size of File"
CE-09 in the Web page. Reduce the number of original pages scanned into the file, or change
the upper limit set in "Maximum Size of File".
The maximum number of destinations that can be searched has been exceeded.
CE-12
Increase the number of search characters to narrow the range of the LDAP search.
The memory became full during scanning. Scan less pages, lower the resolution, or
MEMORY change the colour mode so that the file size is smaller, and try scanning again.
FULL For the scan mode settings, see
Scanning". (See Help in the Web page for explanations of each of the settings.)

IF YOUR E-MAIL IS RETURNED

If a Scan to E-mail is not successfully transmitted, an e-mail informing you of this fact is sent to the return address
configured in the SMTP server. If this happens, read the e-mail and determine the cause of the error, and then
repeat the transmission.
"Editing and deleting programmed transmission
"STORING SCANNING SETTINGS - Network
3
Select the driver or utility that you
wish to remove from the list, and click
the appropriate button to remove it.
For more information, refer to your operating
manual or to the help files for your operating
system.
4
Restart your computer.
Solution
destinations".
- 71 -
"VARIOUS SERVER
Page
—
59, 62
—
59
61
67
54