Henny Penny LVE-102 Operation Manual page 55

6-1. TROUBLE SHOOTING
GUIDE (Continued)
Problem
Oil foaming or boiling
over top of vat
Oil will not
drain from vat
Filter motor runs but
pumps oil slowly
Bubbles in oil during
������������
Control error code "E-31"
Filter motor will not run
Sept. 2007
Cause
• Water in oil
• Improper or bad oil
• ���������
• Improper rinsing after
cleaning the vat
• Drain valve clogged with
crumbs
• Drain trough clogged
• Filter line connections loose
• Filter paper or pad clogged
• Filter pan not completely
engaged
• Filter pan clogged
• ������������
line receiver on fryer
• Elements are up
• Power cord for vat #1 is not
plugged-in
• Open circuit
• The thermal reset button on
the rear of the pump motor is
tripped
6-2
Model LVE-102, 103, 104
Correction
• Drain and clean oil
• Use recommended oil
• ��������������
• Clean and rinse vat and then dry
thoroughly
• Open valve, force cleaning brush through
drain
• Remove right side panel and remove plug
from end of trough and clean trough
• T�����������������
• �������������
• ���������������������
completely into the receiver on the fryer
• Clean pan and change paper or pad
• Change O-ring
• Lower elements back into vat
• Plug power cord into receptacle
• Breakers in fryer tripped-open left door
and reset breaker on fryer
• Allow time for the motor to cool and then,
using a screwdriver, press hard against the
button until it clicks