E-Log (Error Code Log) - Henny Penny LVE-102 Operation Manual

5-1. ADVANCED PRODUCT
SETTINGS (Continued)

5-2. E-LOG (error code log)

Dec. 2007
8. Press button until "FULL HT" shows in the display along with
the full heat value in seconds, which means the heat is on as soon as
a timer button is pressed, for the programmed length of time. Press
the product buttons
value of 0 to 90 seconds.
9. Press button until "PC FACTOR" shows in the display along
with the proportional temperature, which helps to keep the oil from
over-shooting the setpoint temperature. Press the product buttons
• Use button to go back to previous menu items.
• Press X����������������������������
to the PRODUCT SELECTN step.
• Press X button a second time to exit PROD COMP mode.
1. Press and hold
display, followed by ENTER CODE.
2. �����������������������������
"COMP" show in the displays.
3. Press button and "E-LOG" shows in the display.
ü
4. Press right ��������������������������
on the display, along with *NOW*".
5. Press and if an error was recorded, "B" and the date, time, and
error code information shows in display. This is the latest error code
that the controls recorded.
6. Press and the next latest error code information can be seen. Up
to 10 error codes (B to K) can be stored in the E-Log Section.
Press and hold the right
the error.
5-2
Model LVE-102, 103, 104
to change this value of 0 to 50 degrees.
and buttons until LEVEL - 2 shows in the
ü
button to view a brief description of
to change this