Fluid Hose
Hose Assembly
Assembly and
Fluid
Fluid
Hose
Assembly
The Graco shielded waterborne hose has three
layers. An outer jacket (FJ), a conductive layer (FC),
and an inner FEP tube (FT). The hose must be
stripped to the dimensions shown at each end.
At At At the
the gun
the
After stripping the hose, loosely assemble the gun
bracket and strain relief fitting in the orientation
shown.
Slide the barrel inlet fitting onto the hose, and then
press in the barbed fitting until it bottoms out on the
shoulder.
3A7504A
and Repair
Repair
and
Repair
gun end:
gun
end:
end:
Repair Kits and Accessories
At At At the
the isolation
the
isolation system:
isolation
(WB 100, HydroShield)
NOTICE
NOTICE
NOTICE
Be careful not to cut into the inner tube (FT) of the
hose when stripping the hose. Nicks or cuts in the
FEP tube will cause premature hose failure.
system:
system:
91