Air Caps - Graco Pro Xp 60 WB Instructions Manual

Air Caps

Air Caps Caps
Air Air Caps
Air Cap Cap Selection Selection Guide
Air Air Cap Selection
To reduce the risk of an injury, follow the
Pressure Relief Procedure, page
removing or installing a fluid nozzle and/or air cap.
The charts in this section can assist you in selecting
an air cap.
• Keep in mind that more than one air cap can meet
your finish requirements.
• When selecting an air cap, consider coating
properties, part geometry, pattern shape, pattern
size, and operator preferences.
80
Guide
Guide
33, before
Measurements Measurements Measurements
All air cap pattern shapes and lengths in the following
charts were measured under the following conditions,
unless otherwise noted:
Note
Pattern shape and length are
material-dependent.
• Distance to target: 10 in. (254 mm)
• Inlet air pressure: 50 psi (34 kPa, 3.4 bar)
• Fan air: adjusted for maximum length
• Fluid flow rate: 10 oz/min (300 cc/min)
3A7504A