Graco Pro Xp 60 WB Instructions Manual page 27

5. Turn ON (I) the ES On-Off switch (J).
6. Set the gun air regulator to deliver a minimum
45 psi (0.32 MPa, 3.2 bar) at the gun when
triggered, to ensure full spraying voltage.
Table 8 8 8 Pressure Table Table Pressure Pressure Drop Drop Drop
Air Air Hose Air Hose Hose
Length Length in in in ft ft ft (m) Length (m) (m)
using 5/16 5/16 inch inch (8 (8 (8
using using 5/16 inch
mm) mm) diameter mm) diameter diameter hose hose hose
15 (4.6)
25 (7.6)
50 (15.3)
3A7504A
Air Regulator Air Air Regulator Setting Regulator Setting Setting
in in in psi psi (MPa, (MPa, bar) bar)
psi (MPa, bar)
with with gun with gun triggered gun triggered triggered
55 (0.38, 3.8)
65 (0.45, 4.5)
80 (0.56, 5.6)
7. Verify that the ES indicator (K) [Hz indicator on
Smart guns] is lit.
Table 9 9 9 LED LED Indicator Indicator Colors
Table Table LED Indicator
Indicator
Indicator Indicator
Color Color Color
Green When spraying, the indicator
should remain green, indicating
sufficient air pressure to the
alternator turbine.
Amber If the indicator changes to amber
after one second, the air pressure
is too low. Increase air pressure
until the indicator is green.
Red If the indicator changes to red
after one second, the air pressure
is too high. Decrease air pressure
until the indicator is green. To
maintain a higher application air
pressure, install ES On/Off Valve
Restrictor Kit 26A160. Adjust the
pressure as needed to ensure the
indicator remains green.
8. Shut off the air to the gun. Turn OFF (O) the ES
On-Off switch (J).
9. Start the pump. Adjust the fluid regulator to
achieve the production rate that you want.
Note
The round spray air cap is optimized
for a production rate of 5 oz/min (150
cc/min). For best round spray results,
limit the production rate to 10 oz/min
(300 cc/min) or less.
Gun Setup
Colors
Colors
Description
Description Description
27