Replacement - Graco Pro Xp 60 WB Instructions Manual

Figure 43 Smart Module
Figure 44 Align Ribbon Cables
Air Swivel Swivel and and Exhaust Exhaust Valve
Air Air Swivel and Exhaust

Replacement

Replacement Replacement
1. Follow the steps in
Prepare the Gun for Service, page
3A7504A
2. To replace the air exhaust valve:
3. To replace the air inlet swivel:
Valve
Valve
48.
Figure 45 Air Inlet Fitting and Air Exhaust Valve
a. Remove the clamp (43) and the exhaust tube
(36).
b. Unscrew the swivel (21) from the gun handle
(16). The swivel is a left-hand thread.
Remove the bracket (104).
c. Pull the exhaust valve (19) from the handle
(16). Inspect the o-ring (19a) and replace if
necessary.
d. Install the o-ring (19a*) on the exhaust valve
(19). Lubricate the o-ring with a light coating
of non-silicone grease.
e. Install the exhaust valve (19) in the handle
(16).
f. Apply thread sealant to the top threads of the
swivel (21). Position the bracket (104) and
screw the swivel into the gun handle (16).
Torque to 75–85 in-lb (8.4–9.6 N•m).
g. Check that the nuts (102, 105) are tight.
h. Install the tube (36) and clamp (43).
a. Unscrew the swivel (21) from the gun handle
(16). The swivel is a left-hand thread.
b. Apply thread sealant to the top threads of the
swivel. Screw the swivel into the gun handle.
Torque to 75–85 in-lb (8.4–9.6 N•m).
Repair
63