Graco Pro Xp 60 WB Instructions Manual page 26

Gun Setup
Table 7 7 7 LED LED Indicator Indicator Colors
Table Table LED Indicator
Indicator
Indicator Indicator
Color Color Color
When spraying, the indicator
Green
should remain green, indicating
sufficient air pressure to the
alternator turbine.
Amber If the indicator changes to
amber after one second, the air
pressure is too low. Increase
air pressure until the indicator
is green.
Red If the indicator changes to
red after one second, the air
pressure is too high. Decrease
air pressure until the indicator
is green. To maintain a higher
application air pressure, install
ES On/Off Valve Restrictor Kit
26A160. Adjust the pressure
as needed to ensure the
indicator remains green.
f. Verify that the air cap pressures meet HVLP
requirements of 10 PSI (0.07 MPa, 0.7
bar) or less using the HVLP verification kit
25E919. See manual 3A6833. Adjust the
fan air adjustment valve (F) and atomizing
air restrictor valve to achieve 10 PSI or less
as needed.
g. Verify that the ES indicator (K) [Hz indicator
on Smart guns] remains green.
5. Continue with steps 18–23 in the
Gun Setup Procedure, page
26
Colors
Colors
Description
Description Description
20.
Round Spray Spray Gun Gun Setup
Round Round Spray Gun
To achieve a round spray pattern, do the following:
1. Install a round spray kit. See Round Spray
Accessories in Gun Accessories, page
achieve a soft pattern for small parts or increased
transfer efficiency, select the medium pattern or
small pattern models.
2. Follow steps 1–11 in the
Gun Setup Procedure, page
3. Fully open the fluid adjustment valve (H)
counterclockwise.
4. Adjust the air in the air cap.
a. Fully close the atomizing air restrictor valve
(G) counterclockwise. Then, open the
atomizing air restrictor valve (G) one turn.
b. Fully close the fan air adjustment valve (F)
clockwise.
Setup Procedure Procedure
Setup Procedure
88. To
20.
3A7504A