Graco Pro Xp 60 WB Instructions Manual page 17

Air Supply Supply Line Line
Air Air Supply Line
To reduce the risk of electric shock or other serious
injury, you must:
• Use the electrically conductive red-colored
Graco Grounded Air Hose for the gun air supply.
• Do not use the black or gray-colored Graco air
hoses.
• Connect the hose ground wire to a true earth
ground.
3A7504A
1. Install an air line filter/water separator (AS) on
the main air supply line to ensure a dry, clean air
supply to the gun.
Note
Dirt and moisture can ruin the
appearance of your finished workpiece
and can cause the gun to malfunction.
See Typical Installation, page
2. Install a bleed type air shut-off valve (AB) and
air regulator (PR) on the gun air supply line to
control air pressure to the gun.
3. Connect the red-colored Graco Electrically
Conductive Air Hose (HG) between the gun air
regulator (PR) and the gun's air inlet. The gun
air inlet fitting has a left-hand thread. Connect
the air supply hose ground wire (GND) to a true
earth ground.
Note
Some isolation systems provide controls
to regulate the air to the spray gun.
Consult the isolation system manual for
proper installation.
Installation
15.
17