How To Configure A Cellular Interface - ZyXEL Communications ZyWALL USG 2000 User Manual

Chapter 7 Tutorials
Drag physical port 5 onto representative interface ge4 and click
2
Figure 70 Configuration > Network > Interface > Port Grouping Example
Click Dashboard, and look at the Interface Status Summary. Ethernet
3
interface ge4 has a status of Port Group Up if it is connected or Port Group
Down if it is not connected. Ethernet interfaces ge5 has a Status of Port Group
Inactive.
Figure 71 Dashboard: Interface Status Summary After Port Grouping

7.2 How to Configure a Cellular Interface

Use 3G cards for cellular WAN (Internet) connections.
the compatible 3G devices. In this example you install or connect the 3G card
before you configure the cellular interfaces but is also possible to reverse the
sequence.
Make sure the 3G device's SIM card is installed.
1
Install the 3G device in the ZyWALL's PCIMCIA slot or connect it to one of the
2
ZyWALL's USB ports.
122
.
Apply
Table 256 on page 891
ZyWALL USG 2000 User's Guide
lists