Removing The Rear Brake Disc; Installing The Rear Brake Disc - KTM 450 EXC EU 2013 Repair Manual

14
WHEELS
14.6.3 Removiq the rear brake disc
14.6A
Installlna: the rear brake disc
106
- Position chain adjuster . Mount nut but do not tighten it yet.
- Make sure that chain adjusters are litted correctly on adjusting screws
- Check the chain tension.
( ~
p. 107)
- Tighten nut
Guideline
I
Nut, rear wheel spindle
I
M20x1.5
180
Nm
(59
Ibl
It)
• Info
I
The wide adjustment range 01 the chain adjusters (32 mm (1.26 in))
enables different secondary ratios with the same chain length.
Chain adjusters can be turned by 180·.
- Operate the loot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
Finishing work
- Remove the motorcycle from the lilt stand.
( ~
p. 12)
Preparatory work
- Raise the motorcycle with the lift stand.
( ~
p. 12)
- Remove the rear wheel.
( ~
p. 104)
Main work
- Remove screws . Take off the brake disc.
Main work
- Clean the contact surface 01 the brake disc.
- Position the brake disc with the label lacing outward. Mount and tighten screws
Guideline
Screw, rear brake disc
M6
Finishine; work
- Install the rear wheel.
( ~
p. 105)
14
Nm
(10.3 Ibl
It)
- Remove the motorcycle from the lilt stand.
( ~
p. 12)
Loctile'" 243™